Lab‎ > ‎

Equipment

The space of the lab is more than 105m2 . Everyone has his/her individual working space.



The IC Design and Embedded System has many hardware and software for research and teaching. Some of them are listed as follows:



 
SMIMS SoC and FPGA Board
  • ARM Cortex A8
  • Linux and higher
  • 2Gb DDR SDRAM 
  • 2Gb NAND Flash 
  • HDMI 
  • 7.0 inch Touch LCD Panel 
  • Xilinx Spartan 6 FPGA XC6SLX150 
  • Ethernet
  • USB 2.0x1 + USB1.1 x1
  • Multifunctional verification software
  • SMIMS debugging tooles

MTZIGBEE Development Board
  • Create MT-ZigBee MSP430 x2
  • Create MT-ZigBee Base Module/430 module)
  • RS232 Cable
  • DC Adapter 5V
  • DC Power Cable 

 
Module for IoT (Internet of Things)
  •  ZigBee Module
  • GPS Module
  • Serial RF 
  • Bluetooth Module
  • GPS Antenna
  • Gyroscope


 
VeriLite Altera C4
  • On-board Altera Cyclone IV EP4CE30F23C8 FPGA
  • Use USB 2.0 interface for data transfer
  • USB download FPGA configuration through USB
  • Up to 35 additional available I/Os
  • RS232
  • 8 user-defined LEDs
  • 2 user-defined push buttons
  • 2 user-defined dip switches
  • Download FPGA configuration through USB
  • Powered through USB +5V
 
iRobot
  • iRobot Create Programmable Robot
  • Advanced Power System Battery
  • Fast Charger
  • Battery Case
  • Serial Cable
  • Create Robot 4th Wheel
  • Create Robot Screws (8-pack)
 
PBB Car & Sensors
  • QTI  Module
  • XBee Module
  • XBee to USB connector
  • Two axis Accelerometer  
  • Ultrasonic  Sensor
  • Moter
  • Infrared Sensor
  • Bread board
 
Parrot AR.Drone 2.0
  • ARM9 RISC 32-bit Processor
  • DDR RAM 128 MB
  • Wifi b/g
  • Linux OS
  • Front Camera
  • Bottom Camera

 
Intel Galileo Development Board
  • Intel® Quark™ SoC X1000 (16K Cache, 400 MHz)
  • 256 MB DDR3
  • 512 kb embedded SRAM, 8 MB NOR Flash,
  • 8 kb EEPROM standard on the board,
  • support for microSD card up to 32 GB.


Software and EDA tools for IC Design
The IC Design and Embedded System Lab has many tools for IC Design, including Cell-based IC Design Tools, Full-custom IC Design Tools. Some of them are listed as follows:
 
 Cell based Design Flow
 
 Layout Tools - Layker
 
LVS&DRC tools - 
 Calibre 


Comments